Login | Sign Up
ErrorKey - Search engine for Error codes and messages     
  Cisco 6400:ATM  [ 57 result(s) ]
CISCO 6400 
  - %ATM-4-UNMATCHUNIVERSIONSSCOP: sig_db->namestring, rcv N(SQ)=0 in BeginPdu at UNI 3.1 CISCO 6400
This message appears on the console when the two ATM UNI versions on either side do not match. For example, the Cisco 6400 is configured with UNI version 3.1 and the device attached to it is configured for UNI version 3.0.
Change the UNI version on either side to match the other. On the Cisco 6400 switch side, use the atm uni version command on the interface specified in the error message.
ATM
Comments
 
  - %ATM-4-ILMIKEEPALIVEFAIL: Restarting ATM signaling and ILMI. Keepalive failure detected. CISCO 6400
Adjacent peer device is not responding to Interim Local Management Interface (ILMI) Keepalive polling.
Check the connection of the ATM interface and the status of the adjacent peer device. Correct them if necessary. Wait and check if ILMI Keepalive comes up again. If the problem persists, copy the warning message exactly as it appears, and report it to your technical support representative.
ATM
Comments
 
  - %ATM-6-ILMIAUTOCFGALREADY: Auto-configuration already enabled. CISCO 6400
ATM autoconfiguration has been enabled.The atm auto-configuration command just entered is ignored.
No action is required.
ATM
Comments
 
  - %ATM-6-ILMINOAUTOCFG: Auto configuration already disabled. CISCO 6400
ATM autoconfiguration has been enabled. The no atm auto-configuration command just entered is ignored.
No action is required.
ATM
Comments
 
  - %ATM-4-ILMICONFIGCHANGE: CISCO 6400
Restarting ATM signaling and ILMI. peer configuration change detected. Configuration of adjacent peer device has been changed.
Wait for the interface to restart.
ATM
Comments
 
  - %ATMSIG-3-FAILASSERT: [chars] CISCO 6400
ATM signaling found an internal critical error.
Contact your technical support representative for assistance.
ATM Signaling
Comments
 
  - %ATMSIG-3-FAILHALFLEGREM: halfLeg removal failed, removeHalfLeg CISCO 6400
ATM signaling failed. There is a half-leg removal error.
Contact your technical support representative for assistance.
ATM Signaling
Comments
 
  - %ATMSIG-3-FAILHALFLEGREM: 2nd halfleg failed, Get 2nd half leg failure. no ifcb CISCO 6400
ATM signaling failed to remove the second half-leg of a connection.
Contact your technical support representative for assistance.
ATM Signaling
Comments
 
  - %ATMSIG-3-NOMEM: [chars] CISCO 6400
ATM signaling could not allocate memory.
Contact your technical support representative for assistance.
ATM Signaling
Comments
 
  - %ATMSIG-3-NOSVC: no SVC, atmSig_findPartyBlockByRef CISCO 6400
The ATM signal control block was not found for a party message.
Contact your technical support representative for assistance.
ATM Signaling
Comments
 
 

 
ATM  (9)
LAN Emulation  (18)
ATM Signaling  (29)
PNNI/IISP  (1)
 
  Prev   1  2  3  4  5  6  Next